GMC Terrain: Universal Remote System / Universal Remote System Operation
Using the Universal Remote System
Press and hold the appropriate
Universal Remote system button for
at least one-half second. The
indicator light will come on while the
signal is being transmitted.
Erasing Universal Remote System Buttons
Erase all programmed buttons when
vehicle ownership is terminated.
To erase:
- Press and hold the two outside
buttons until the indicator light
begins to flash. This should
take about 10 seconds.
- Release both buttons.
Reprogramming a Single Universal Remote System Button
To reprogram any of the system
buttons:
- Press and hold any one of the
buttons. Do not release the
button.
- The indicator light will begin to
flash after 20 seconds. Without
releasing the button, proceed
with Step 1 under
“Programming the Universal
Remote System.”
If equipped, these buttons are in the
overhead console.
This system can replace up to three
remote control transmitters used to
activate devices such as garage
door openers, security systems, and
home automation devices...
Other information:
Warning
Never fill a portable fuel container
while it is in the vehicle. Static
electricity discharge from the
container can ignite the fuel
vapor. You can be badly burned
and the vehicle damaged if this
occurs. To help avoid injury to you
and others:
Dispense fuel only into
approved containers.
Do not fill a container while
it is inside a vehicle, in a
vehicle's trunk, pickup bed,..
If equipped, these buttons are in the
overhead console.
This system can replace up to three
remote control transmitters used to
activate devices such as garage
door openers, security systems, and
home automation devices. These
instructions refer to a garage door
opener, but can be used for other
devices.
Do not use the Universal Remote
system with any garage door opener
that does not ha..