GMC Terrain: Setting Cruise Control / Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
are applied or
is pressed, the
cruise control is disengaged without
erasing the set speed from memory.
Once the vehicle speed reaches
about 40 km/h (25 mph) or more,
briefly press +RES. The vehicle
returns to the previous set speed.
If is on when not in use, –SET
or
+RES could get bumped and go into
cruise when not desired. Keep
off when cruise is not being used.
To set a speed:
Press to turn the cruise
system on...
If the cruise control system is
already activated:
Press and hold +RES on the
steering wheel until the vehicle
accelerates to the desired
speed, then release it...
Other information:
If equipped, this power outlet can be
used to plug in electrical equipment
that uses a maximum limit of 150
watts.
The power outlet is on the rear of
the center console.
An indicator light on the outlet turns
on to show it is in use. The light
comes on when the ignition is on
and equipment requiring less than
150 watts is plugged into the outlet,
and no system fault is detected...
The Diesel Particulate Filter (DPF)
system filters soot particles out of
the exhaust gases. The DPF is
under the vehicle in the exhaust
system.
Depending on a number of factors
monitored by the engine computer,
the DPF will need to be cleaned of
accumulated solids...